Showing 1-16 of 16
SKU: 51-145
Heater motor, 12 Volt, CCW, Permanent magnet - Dim: 4-5/8"L x 3-1/4" dia. with 5/16" dia. x 1-1/8"L shaft with 6-3/4" dia. mounting plate.
SKU: 51-141
Heater Motor, 12 Volt, 2 wires, reversable direction, permanent magnet - Dim: 4-1/2"L x 3" dia. with 5/16" x 1-1/2"L shaft.
SKU: 43-545
Plug for heater switch. Can be used on 3 to 5 wire switches. Fits our switch numbers 53-647, 53-639 and 53-649
SKU: 52-043
Steel Blower Wheel 1-11/16" Offset with 5/16" Bore, CCW, 5-3/4"Dia. x 3-3/8"W (See Above Chart)
SKU: B-448
Dual wheel blower assembly. 12 Volt, 3-speeds; uses one motor with dual shafts.
SKU: 43-517
Resistor Assembly Pigtail for Ford, used on Resistor Assembly 7HZ-18591-A
SKU: 55-380
Single wheel assembly with 3-Speed motor. This blower is ideal for small application. Only has a 9" x 5" footprint with a vent openin... more
SKU: 51-092
Heater Motor, 12 Volt, 2-speed wire wound - Dim: 3-3/4"L x 3" dia. with 5/16" x 1-1/4"L shaft, CCW.
SKU: 55-110
Dual wheel blower assembly - 12 Volt permanent magnet motor with 4 speeds operated from a resistor - Uses dual shaft motor
SKU: 52-042
Steel Blower Wheel, 1/2" Offset with 5/16" Bore, CCW - 5-1/4" Dia. x 3-3/8" Wide. (See Chart Above)
SKU: 51-232
Heater motor, 3 Speed, 12 Volt, wire wound, 3 wires on plug and 1 ground - Dim: 3-3/4"L x 3" dia; 5/16" x 3-1/8"L double shafts.
SKU: 53-537
Switch Knob with 1/4" 'D' shaft receptacle. Used in Evans, Hupp and Lintern heaters in Grumman Olson and Supreme Body stepvans
SKU: 53-649
2-Speed Rotary Heater Switch: Off-Low-High. 3 spade terminals. Fits Older Grumman vehicles.
SKU: 52-040
Plastic Blower Wheel Double 1-7/8" with 5/16" Bore, CW - 3-3/16"Dia. x 3-13/16"W. (See Chart Above)
Mill Supply uses cookies to give you the best shopping experience. If you continue browsing, you agree to the use of cookies. Dismiss