High Output 30,000 BTU 12 Volt Auxiliary Heater with mounting brackets, switch, and 5/8" hose connectors. This unit uses a single motor with dual blower wheels for superior output.
This versatile heater may be mounted either horizontally or vertically. Typical locations include floor, wall or under dash. A simple connection to the heater hoses is made by marking the inlet and outlet tube locations and cutting a hole through the vehicle’s floor or firewall. Grommets are included to protect the heaters hoses when going through the floor or wall. Mounting brackets are provided and the assembly has screws located on both sides for a quick assembly in any direction.
For the dual wheel blower assembly: B-448
For the blower motor only: 51-232
Features:
Hardware Kit Includes:
(2) Mounting Brackets
(2) Y Splicers
(2) Rubber Grommets
(8) Hose Clamps
(4) Screws
(1) 15 AMP Fuse
(1) 3 Speed Switch
(1) Control Knob
Routing Heater Hoses and Connections
Route the heater hose to the engine compartment. It is recommended the heater hose follow the inside of the frame rails for protection from road debris when they are needed to run under the floor. Wire ties or clamps may be used to secure the hose to the frame. Please note that all hoses must clear all driveline or moving parts and must be securely fastened to the frame to avoid potential damage to the hose and cooling system. In the engine compartment, locate where the existing heater hoses pass through the fire wall. On the engine side of the fire wall, cut and insert the Y splicers in the existing heater hoses as close to the firewall as possible. Secure the 'Y' splicer connections with hose clamps (these components are provided in kit), then install the new heater hose to the auxiliary heater. Avoid any sharp bends which may kink the hose and restrict proper flow.
Wiring the Switch
Mount the switch in a convenient location. Route power supply wire from fuse block to 3 speed switch (to C), including inline 15 AMP fuse. Clip plug, then connect the red (to M), orange (to H) and yellow (to L) wires from the heater to the switch. Ground the black wire to the chassis of the vehicle.
This unit has a one year warranty from the date of installation.
Estimated Shipping Dimensions: 17" x 11" x 7"
Weight: 12.95 lbs
Made in: United States
M803012V
Rest assured, when you buy a rust repair panel from Mill Supply, you are going to receive the best there is in the industry. Our purchasers search for the cleanest lines, smoothest curves and best stamped form when they purchase panels like; rockers, rear quarters, cab corners, door skins and other restoration parts. We work hard at keeping our prices down so you're getting the best value for your dollar. Auto body restoration has been our specialty since our founding in 1944 when we started by selling paint and other body shop supplies to local businesses in the Cleveland area. Since then, we have expanded nationwide, and with the internet, often sell overseas. Whether you're repairing a classic to current car, pickup truck, or even your daily driver, we have the restoration panels you need. We distribute parts for Key Parts, Sherman, Golden Star, and others. If you have any question or would like help with ordering please contact us via email or give us a call at 800-888-5072 between 8:00 a.m. - 5:00 p.m. E.S.T. and one of our experienced representatives will be happy to help you.
KEEP UP TO DATE
FOLLOW ALONG FOR SALES, EDUCATIONAL
VIDEOS, UPDATES, AND MORE! @millsupplyinc
Mill Supply uses cookies to give you the best shopping experience. If you continue browsing, you agree to the use of cookies. Dismiss
Email
Facebook
SMS Text
